Linux version 2.4.21-0.11mdk (quintela@bi.mandrakesoft.com) (gcc version 3.2.2 (Mandrake Linux 9.1 3.2.2-2mdk)) #1 Fri Feb 28 13:51:48 CET 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
 BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
 BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
128MB LOWMEM available.
ACPI: have wakeup address 0xc0001000
On node 0 totalpages: 32768
zone(0): 4096 pages.
zone(1): 28672 pages.
zone(2): 0 pages.
Intel AL440LX with broken BIOS detected. The local APIC timer will not be used.
Kernel command line: BOOT_IMAGE=linux ro root=307 quiet devfs=mount hdc=ide-scsi acpi=off
ide_setup: hdc=ide-scsi
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
Detected 266.679 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 532.48 BogoMIPS
Memory: 126176k/131072k available (1410k kernel code, 4508k reserved, 1118k data, 136k init, 0k highmem)
Dentry cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0080fbff 00000000 00000000 00000000
CPU:             Common caps: 0080fbff 00000000 00000000 00000000
CPU: Intel Pentium II (Klamath) stepping 04
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
ACPI: Subsystem revision 20030122
ACPI: Disabled via command line (acpi=off)
PCI: PCI BIOS revision 2.10 entry at 0xfd9cc, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: ACPI tables contain no PCI IRQ routing entries
PCI: Probing PCI hardware (bus 00)
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'U.S. Robotics 56K Voice INT'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
vesafb: framebuffer at 0xf6000000, mapped to 0xc8800000, size 4096k
vesafb: mode is 800x600x16, linelength=1600, pages=3
vesafb: protected mode interface info at c000:4d86
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Looking for splash picture.... found (800x600, 25593 bytes).
Console: switching to colour frame buffer device 80x16
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at port 0x02f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 32000K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xfc98-0xfc9f, BIOS settings: hdc:DMA, hdd:pio
hda: Maxtor 53073U6, ATA DISK drive
hdb: Maxtor 84320D4, ATA DISK drive
blk: queue c03cb420, I/O limit 4095Mb (mask 0xffffffff)
blk: queue c03cb55c, I/O limit 4095Mb (mask 0xffffffff)
hdc: LITE-ON LTR-12101B, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: host protected area => 1
hda: 60030432 sectors (30736 MB) w/2048KiB Cache, CHS=3736/255/63, UDMA(33)
hdb: host protected area => 1
hdb: 8439184 sectors (4321 MB) w/256KiB Cache, CHS=525/255/63, UDMA(33)
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 p6 p7 p8 p9 >
 /dev/ide/host0/bus0/target1/lun0: p1
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 108k freed
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Mounted devfs on /dev
Freeing unused kernel memory: 136k freed
Real Time Clock Driver v1.10e
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 14:28:15 Feb 28 2003
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 11 for device 00:07.2
usb-uhci.c: USB UHCI at I/O 0xfca0, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usbdevfs: remount parameter error
hub.c: new USB device 00:07.2-1, assigned address 2
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,7), internal journal
hub.c: USB hub found
hub.c: 7 ports detected
Adding Swap: 811240k swap-space (priority -1)
hub.c: new USB device 00:07.2-1.1, assigned address 3
usb.c: USB device 3 (vend/prod 0x4a7/0x201) is not claimed by any active driver.
hub.c: new USB device 00:07.2-1.2, assigned address 4
usb.c: USB device 4 (vend/prod 0x573/0x4d00) is not claimed by any active driver.
hub.c: new USB device 00:07.2-1.3, assigned address 5
usb.c: USB device 5 (vend/prod 0x572/0x1) is not claimed by any active driver.
i2c-core.o: i2c core module version 2.7.0 (20021208)
i2c-algo-usb.o: i2c usb algorithm module
Linux video capture interface: v1.00
usb.c: registered new driver usbvision
usbvision: HAUPPAUGE WINTV-USB USA found
i2c-algo-usb.o: hw routines for usbvision #0 registered.
inserting floppy driver for 2.4.21-0.11mdk
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
  Vendor: LITE-ON   Model: LTR-12101B        Rev: LS39
  Type:   CD-ROM                             ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,9), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
MSDOS FS: IO charset iso8859-1
MSDOS FS: Using codepage 850
MSDOS FS: IO charset iso8859-1
MSDOS FS: Using codepage 850
Linux Tulip driver version 0.9.15-pre12 (Aug 9, 2002)
PCI: Found IRQ 9 for device 00:0e.0
eth0: ADMtek Comet rev 17 at 0xf800, 00:20:78:05:A4:F4, IRQ 9.
PCI: Found IRQ 9 for device 00:0f.0
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0f.0: 3Com PCI 3c900 Boomerang 10baseT at 0xfc40. Vers LK1.1.18-ac
 00:60:08:aa:0a:94, IRQ 9
  product code 4b46 rev 00.0 date 10-26-97
  Internal config register is 302d8, transceivers 0xe108.
  8K word-wide RAM 3:5 Rx:Tx split, 10baseT interface.
  Enabling bus-master transmits and whole-frame receives.
00:0f.0: scatter/gather enabled. h/w checksums disabled
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
es1371: version v0.32 time 14:25:41 Feb 28 2003
PCI: Found IRQ 10 for device 00:0d.0
es1371: found chip, vendor id 0x1274 device id 0x1371 revision 0x08
es1371: found es1371 rev 8 at io 0xfcc0 irq 10
es1371: features: joystick 0x0
ac97_codec: AC97  codec, id: TRA35 (TriTech TR A5)
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP]
parport0: irq 7 detected
parport0: Printer, HEWLETT-PACKARD DESKJET 895C
lp0: using parport0 (polling).
Splash status on console 0 changed to off
FAT: bogus logical sector size 64543
VFS: Can't find a valid FAT filesystem on dev 03:40.
VFS: Can't find ext3 filesystem on dev ide0(3,64).
VFS: Can't find ext2 filesystem on dev ide0(3,64).
FAT: bogus logical sector size 64543
VFS: Can't find a valid FAT filesystem on dev 03:40.
FAT: bogus logical sector size 64543
VFS: Can't find a valid FAT filesystem on dev 03:40.